Search for: All records

Direct numerical simulations are performed to study turbulent Rayleigh–B ́enard convection in a vertical cylindrical cavity exposed to a uniform axial magnetic field. Flows at high Hartmann and Rayleigh numbers are considered. The calculations reveal that, similarly to the behavior observed in Rayleigh–Benard convection with strong rotation, flows under a strong magnetic field develop a central vortex, whereas the heat transfer is suppressed. 

Direct numerical simulations are carried out to study the flow structure and transport properties in turbulent Rayleigh–Bénard convection in a vertical cylindrical cell of aspect ratio one with an imposed axial magnetic field. Flows at the Prandtl number $0.025$ and Rayleigh and Hartmann numbers up to $$10^{9}$$ and $1400$ , respectively, are considered. The results are consistent with those of earlier experimental and numerical data. As anticipated, the heat transfer rate and kinetic energy are suppressed by a strong magnetic field. At the same time, their growth with Rayleigh number is found to be faster in flows at high Hartmann numbers. This behaviour is attributed to the newly discovered flow regime characterized by prominent quasi-two-dimensional structures reminiscent of vortex sheets observed earlier in simulations of magnetohydrodynamic turbulence. Rotating wall modes similar to those in Rayleigh–Bénard convection with rotation are found in flows near the Chandrasekhar linear stability limit. A detailed analysis of the spatial structure of the flows and its effect on global transport properties is reported. 

Abstract The ATLAS detector is installed in its experimental cavern at Point 1 of the CERN Large Hadron Collider. During Run 2 of the LHC, a luminosity of  ℒ = 2 × 10³⁴cm^-2s^-1was routinely achieved at the start of fills, twice the design luminosity. For Run 3, accelerator improvements, notably luminosity levelling, allow sustained running at an instantaneous luminosity of  ℒ = 2 × 10³⁴cm^-2s^-1, with an average of up to 60 interactions per bunch crossing. The ATLAS detector has been upgraded to recover Run 1 single-lepton trigger thresholds while operating comfortably under Run 3 sustained pileup conditions. A fourth pixel layer 3.3 cm from the beam axis was added before Run 2 to improve vertex reconstruction and b-tagging performance. New Liquid Argon Calorimeter digital trigger electronics, with corresponding upgrades to the Trigger and Data Acquisition system, take advantage of a factor of 10 finer granularity to improve triggering on electrons, photons, taus, and hadronic signatures through increased pileup rejection. The inner muon endcap wheels were replaced by New Small Wheels with Micromegas and small-strip Thin Gap Chamber detectors, providing both precision tracking and Level-1 Muon trigger functionality. Trigger coverage of the inner barrel muon layer near one endcap region was augmented with modules integrating new thin-gap resistive plate chambers and smaller-diameter drift-tube chambers. Tile Calorimeter scintillation counters were added to improve electron energy resolution and background rejection. Upgrades to Minimum Bias Trigger Scintillators and Forward Detectors improve luminosity monitoring and enable total proton-proton cross section, diffractive physics, and heavy ion measurements. These upgrades are all compatible with operation in the much harsher environment anticipated after the High-Luminosity upgrade of the LHC and are the first steps towards preparing ATLAS for the High-Luminosity upgrade of the LHC. This paper describes the Run 3 configuration of the ATLAS detector.